[Home] [Industrial Vibrators] [DC Motors] [DC Blowers]
[Tarp Roll-up Gearmotors] [Gearboxes] [E-mail Karrier Company]

Return to Karrier Company's Home Page

"The Next Generation In Actuation"
Karrier Company proudly present...
The M-125


M-125 Standard Options and Pricing

PERFORMANCEPERFORMANCE

 DUTY CYCLEDUTY CYCLE
UNIT WEIGHTUNIT WEIGHT MOUNTING ORIENTATIONMOUNTING ORIENTATION

The M-125 is nearly a completely autonomous hydraulic actuator. Just add electricity. Forget about running all those hydraulic lines, installing expensive control valves, pumps, cylinders, filters and reservoirs. All the hydraulic links to the controls are eliminated. Instead of hydraulic links, the M-125 is connected to the controls by electric wires. This eliminates cost and lets you use hydraulic actuation in a wider array of applications.

The cylindrical shape of the M-125 measures approximately 2.5" in diameter. Motor and pump design were carefully considered to balance cost, life and performance. The reservoir is sealed with O-rings inside the aluminum housing to prevent leaks. The design of the rotary pump allows the M-125 to hold loads safely without expensive internal valving.




If you crash the system, the risk of oil loss is greatly reduced because of the compact design. The M-125 is available with a microprocessor control (ERV) to prevent the system from overloading. The sealed hydraulic system is impervious to contaminates.

M-125 Structural and Design Features:
  • Integral Design Includes: Motor, Pump, Reservoir and Cylinder
  • 1500 Pound Maximum Force
  • 1" to 37" Stroke
  • 10 to 36 Volt DC
  • -20 to 110 Degree F Operating Temperature Range
  • Indoor/ Outdoor Environment Ready
  • Steel Nitrotec Rod
  • Sealed Aluminum Exterior Housing
  • Trunion Mounting
  • No Leaking Connectors
  • Microprocessor Protection Available (ERV)
  • EASY TO INSTALL AND OPERATE

Output Performance:
  • Chart Below Indicates Force/ Speed/ Current Draw
Top


Duty Cycle:
  • Chart Below Indicates Actuator Duty Cycle
    • Top


    Physical Weight:
  • Chart Below Indicates Actuator Weight
    • Top


    Mounting Orientation:
    • Drawing Below Indicates Approved Mounting Orientations
    Top


    The M-125 Shown On This Page Represents Standard Performance, Duty Cycle and Stroke Travel Speed. If Our Standard Performance Does Not Meet Your Application Requirements, Please "Tell Us What You Want." Click The Button Below, Answer A Few Questions And Send Your Requirements Directly To Karrier Company.

    Meet ERV. 

    ERV is short for Electronic Relief Valve.  ERV eliminates the need for the conventional relief valve.

    erv100.gif (69331 bytes)

    The ERV-100 is a microprocessor controller especially designed for our hydraulic actuators and has the  following functions:

    1.  Limit the actuator force to a predetermined value set at the factory.

    2.  Prevent the actuator from being started in the same direction after it has reached the set force limit.

    3.  Protect the drive motor from overheating by limiting the cycle time.

    4.  The ERV-100 requires at least one relay in the electrical circuit.

    DATA:

         Current Settings..................................................20 to 100 Amp.
         Cycle Limit.................................................2000 amp-sec/5 min.
         Voltage..................................................................9-14 volts DC
         Temperature............................................................0-120 deg. F
         Sensing........................................................................Inductive


    Tell Us What You Want

    M-125 Standard Options and Pricing



    Back To The Top Of This Page

    Phone 330-823-9597 Fax 330-829-9001


    FastCounter by bCentral